zone gridpoint list command
Syntax
- zone gridpoint list keyword
Primary keywords:
acceleration apply damping displacement dynamic extra fluid force group information position system temperature velocity zone
Display gridpoint information in the console. The following keywords are available to choose which information to list.
- acceleration <local>
Gridpoint acceleration. The optional local keyword specifies that acceleration should be reported in local gridpoint coordinates; the default is in model/global coordinates.
- apply <local>
Gridpoint applied forces. The optional local keyword specifies that acceleration should be reported in local gridpoint coordinates; the default is in model/global coordinates.
- damping
Gridpoint damping parameters
- displacement <local>
Gridpoint displacements. The optional local keyword specifies that acceleration should be reported in local gridpoint coordinates; the default is in model/global coordinates.
- dynamic
Gridpoint dynamic damping parameters
- fluid
Gridpoint information on fluid, including pore-pressure and fluid fixity, as well as saturation, Biot modulus, fluid modulus and fluid tension if
model configure fluid
has been specified.
- force <local>
Gridpoint unbalanced forces. The optional local keyword specifies that acceleration should be reported in local gridpoint coordinates; the default is in model/global coordinates.
- group <slot s >
Gridpoint group assignments. When the optional slot is supplied, only groups in that slot are listed; otherwise all groups are listed.
- information
General gridpoint information: position, mass, fixity, and applied-velocity for each gridpoint. This is the default option if no keyword is given when zone.gridpoint.list is used.
- position
Position coordinates of gridpoint.
- system
Gridpoint local coordinate system, if the local coordinate system is specified.
- temperature
Gridpoint temperature; only available if
model configure thermal
has been specified.
- velocity <local>
Gridpoint velocities. The optional local keyword specifies that acceleration should be reported in local gridpoint coordinates; the default is in model/global coordinates.
- zone
List of zones connected to gridpoint.
Was this helpful? ... | PFC 6.0 © 2019, Itasca | Updated: Nov 19, 2021 |