Examples
This section contains a number of examples detailing PFC usage.
For specific details of the PFC model components (e.g., balls, clumps, walls, and contacts), see Model Components.
- Tutorials
- Balls in a Box
- Clumps in a Box
- Attributes and Properties
- Using the CMAT
- Generating a Bonded Assembly
- Replicating a Particle Size Distribution
- Inclusions in a Matrix
- Hopper Discharge
- Using FISH Callbacks
- Table Tennis
- Shallow Foundation
- Slip on a Fault
- Creation of a Synthetic Rock Mass (SRM) Specimen
- FISH Contact Model
- Verification Problems
- Measure Logic
- Strength of a Face-Centered Cubic Array of Spheres
- Tip-Loaded Cantilever Beam
- Linear Contact Model: Calibrating the Normal Critical Damping Ratio
- Hertz Contact Model: Complex Loading Paths
- Wave Propagation in Particle Assemblies
- Rolling Resistance Linear Contact Model: Single Ball on a Flat Surface
- Rolling Resistance Linear Contact Model: Repose Angle
- Adhesive Rolling Resistance Linear Contact Model: Repose Angle
- Burger’s Contact Model: Stress Relaxation
- Sliding Wedge
- Spring Network Contact Model Capabilities
- Simulating Square Permanent Magnets
- Pull-Test for a Grouted Cable Anchor in a PFC Rigid Block Model
- Shear Pull-Tests for a Hybrid Bolt in PFC3D
- Example Applications
- Hopper Flow
- Probing a Granular Specimen
- Speeding Up Granular Flow Simulations
- Ribbon Blender
- Fragmentation Analysis during a Uniaxial Compression with Crack Tracking Using Fractures
- DFN Generation, Analysis, and Simplification
- Rock Testing
- Rigid Block Model of Flying Buttresses
- Rigid Block Model of a Rockslide
- Genesis and Testing of a Soft-Bonded Material
- Simple Rigid Block Bonded-Block Modeling (BBM)
- Rigid Block Model of Tunnel Excavation
- Using the Rigid Body Spring Network Paradigm
- Particle Inlets
Was this helpful? ... | Itasca Software © 2024, Itasca | Updated: Dec 14, 2024 |